Position the unit closely in front of the water supply line and power supply.Toward the bottom of the dishwasher, remove the 2 screws attaching the lower cover and set the cover aside.Remove the rear plastic shipping brace.Unbox and remove any packaging material from the unit.To ensure proper drainage install the dishwasher no farther than 12 feet from the sink and drain lines and do not kink or bend the water supply line and drain hoses.Extend the water supply line and power supply outward and loosely tape both to the floor, approximately 14" to 16" apart.Use a 2 1/2" diameter hole saw to drill a hole in the target areas shown on the template.In case there are no openings on the sides of the cabinet cavity. Use the template included, located on top of the unit and the manual to determine the clearance on the side of the cabinet where the cabinet meets the back wall to feed your water and drain supply line and power cord if needed.Be sure to turn off the circuit breaker that connects with the dishwasher.Make sure to turn off the sink's water valve where the dishwasher is to be connected.Make sure you have the following tools required. Please read through the instructions in the manual or watch this video in its entirety before attempting installation and be sure to pause the video when necessary.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |